top of page
Search

What You Get

  • charrich560
  • Apr 27
  • 1 min read

Two models of ZoneRanger pickups are available:


Focus-F (Filtertron-sized body, English mount compatible) and Focus-G (standard full-sized humbucker form factor). Both fit standard humbucker mounting rings and body routs.


The Focus-G is a good choice for replacing standard full-sized humbucking pickups in 24 3/4" to 25 1/2" scale length instruments, and covers the most traditional range of tones for most players.


The Focus-F has slightly narrower rail spacing, and is recommended for 25 1/2" scale length instruments for players in cleaner styles to replace pickups in instruments with stronger high end content. The body of the pickup is slightly smaller and the pickup will fit in a Filtertron pickup ring with "English" mount.


Voice Control Board (DVB-01 and DVB-02): Pre-assembled, very small circuit board with all voicing components included.  Connections to the board are solderless screw terminals, which make for easy installation. Supports both switched (two-voice) and potentiometer (continuous) voicing with no additional parts needed beyond the switch or pot.  Both dual-pickup (DVB-01)  and single-pickup (DVB-02) boards are available. 


Standard wiring: Four conductors plus ground cable,  following Seymour Duncan ™ color codes.  In-phase with Seymour Duncan ™  humbuckers. Designed to mix well with most traditional 7K–8.5K neck humbuckers if you’re installing only one ZoneRanger in the bridge position.


Installation: Drop-in replacement for any standard full-sized humbucker. The small DVB voicing board connects between the pickup cable and your guitar’s existing volume and switching controls.


Fully passive—no batteries, no active electronics. Compatible with all existing instruments equipped with humbucking pickups and passive control circuitry.

 
 
 

Recent Posts

See All
Not Just Another Quad-Rail Pickup

Quad-rail pickups aren’t new. Designs from Kent Armstrong, Kramer, Warman, and others have used four rails on a common baseplate—but those are essentially two standard dual-rail single-coil-sized humb

 
 
 
Why Coil Splitting Doesn’t Get There

Coil splitting is the most common attempt to get tonal versatility from a humbucker. It completely or partially disables one coil out of the two coils to approximate a single-coil sound. In practice,

 
 
 
The Practical Payoff: Your Sound, Any Rig, Any Room

The reason this matters—whether you’re gigging, recording, practicing at home, or sitting in with a band you just met—is that the ZoneRanger system moves a huge chunk of control of your tone from your

 
 
 

Comments


bottom of page